A water pump is a machine that transports liquids or pressurizes liquids. It transfers the mechanical energy of the prime mover or other external energy to the liquid to increase the energy of the liquid. It is mainly used to transport liquids including water, oil, acid and alkali liquids, emulsions, suspoemulsions and liquid metals. So about its debugging method, do you know it? Follow the editor of UTB water pump for a simple understanding!
After the installation of the pump unit and accessories is completed, a stand-alone test shall be carried out, and a load test shall be carried out when conditions permit.

The single pump test should be carried out according to the following methods and steps: Check whether the power distribution cabinet meets the requirements and whether the motor terminals meet the product requirements. Remove the key of the motor and water pump coupling, and separate the motor and water pump. Carry out a test run on the motor to check whether the steering and sound are normal. Use the key to connect the motor and the water pump, turn it manually, and check if there is noise when the water pump rotates. It is difficult to start the pump for a long time without water, so as not to damage the bearings of the pump. Close the gate valve of the water pump pipe network and open the gate valve of the test pipe. Start the water pump unit, observe the pressure gauge value on the pipeline, adjust the gate valve of the test pipeline to control the pipeline pressure, and make the pipeline pressure reach the normal working pressure value of the water pump.
In summary, the editor of UTB water pump tells: a brief introduction to the relevant knowledge about the debugging method of the water pump.