Please follow the editor of MT3 Water pump to understand the things you need to know during the use of the pump!
1. If the water pump has relatively minor faults, remember not to let it work. If the packing of the water pump shaft is worn out, it should be added in time. If the pump continues to be used, air leakage will occur. The direct effect of this is that the energy consumption of the motor will increase, which will damage the impeller.
2. If there is a strong vibration during use, you must stop and check what the cause is, otherwise it will also be damaged.

3. When the bottom valve of the water pump leaks, some people will fill the inlet pipe with dry soil and flush the bottom valve with water, which is really undesirable. This is because when the dry soil is put into the water inlet pipe when it starts to work, the dry soil will enter the pump, which will damage the impeller and bearings, which shortens the service life. When the bottom valve leaks, it must be repaired. If it is serious, it needs to be replaced with a new one.
4. Be sure to pay attention to maintenance after use. For example, when the water pump is used up, the water in it should be drained. It is recommended to remove the water pipe and rinse it with clean water.
5. The tape on the water pump should also be removed, and then rinse it with water and dry it in a light place. Don't put the tape in a dark and damp place. Its tape must not be stained with oil, not to mention sticky things on the tape.
6. Carefully check whether there are cracks on the impeller, whether the impeller is fixed on the bearing is loose, if there are cracks and looseness, repair it in time, and clean up if there is dirt on the impeller.
To sum up, the editor of MT3 Water pump tells: about the knowledge of the water pump in the use process, I hope it can help you.